diff --git a/armjtag/README b/armjtag/README
index 21ae5e4..ac364b4 100644
--- a/armjtag/README
+++ b/armjtag/README
@@ -19,15 +19,26 @@ http://www.sparkfun.com/products/9140
 http://www.sparkfun.com/products/9385
 
 The signal name, gpio pins, schematic name, connector pin
-and direction shown here
+and direction shown here.  When looking into the holes of an arm
+20 pin (female) jtag connector.  There should be a key or bit of plastic
+almost two holes wide on one side.  With that key pointed up, looking
+into the holes pin one is the top left corner.  The arm jtag names
+on the left of this list start with pin 1 and go along that side of
+the connector in order.  For ground use any one of the holes on the
+other side except the lower left, pin 2, that is not a ground.
 
-ARM_VREF                   P1-1
-ARM_TRST      22 GPIO_GEN3 P1-15  IN (22 ALT4)
-ARM_TDO     5/24 GPIO_GEN5 P1-18 OUT (24 ALT4)
-ARM_TCK    13/25 GPIO_GEN6 P1-22 OUT (25 ALT4)
-ARM_TDI     4/26 GPIO_GCLK P1-7   IN ( 4 ALT5)
-ARM_TMS    12/27 CAM_GPIO  S5-11 OUT (27 ALT4)
-ARM_GND                    P1-25
+See this page as an example
+http://www.amontec.com/jtag_pinout.shtml
+
+1 ARM_VREF                   P1-1
+2 ARM_TRST      22 GPIO_GEN3 P1-15  IN (22 ALT4)
+3 ARM_TDI     4/26 GPIO_GCLK P1-7   IN ( 4 ALT5)
+4 ARM_TMS    12/27 CAM_GPIO  S5-11 OUT (27 ALT4)
+5 ARM_TCK    13/25 GPIO_GEN6 P1-22 OUT (25 ALT4)
+7 no connect
+9 ARM_TDO     5/24 GPIO_GEN5 P1-18 OUT (24 ALT4)
+
+4-20 ARM_GND                    P1-25
 
 In parenthesis is the gpio pin used and the alternate function setting
 needed in the GPIO to connect it to the edge of the BCM chip.